[Vixion] Panel Line Tutorial

These are what you need to make new panel line at your kit. A

knife and a needle, any needle works. Pick one which is comfortable

to hold

First , draw the panel line use marker or anything else

Slice the part followong the

pattern. Make sure the channel is deep enough.

Make it deeper using needle.

Move following the number. It is important to prevent the edge

change into curvy.Sand it using 400 and then

1000

Make it deeper once again,

this is to remove the dust from sanding, or you can use

toothbrush

It’s done. I usually

use scribber, it’s much more comfortable. The different

between needle and scribber, is scribber more comforatable to use.

Both have the same result , it’s depend on your patience.

Panel lining is all about patience.

There is another method which  using dymo tape . I will

make another tutorial for that